超耐磨地坪漆施工注意事项和地面硬化剂的作用

1，超耐磨地坪漆施工留意事项：雾气时不宜施工假如施工场地不是密封空间，遇到雾气或霜雪等气候，不能施工。假如地坪外表蒙有水汽，也不宜停止施工。延长施工距离冬季低温环境下，地坪漆固化时间变长，所以施工工序之间的时间距离需求延长，测定涂膜的确实干后再施工下一层，否则容易呈现渗色、涂膜脱层等涂膜问题。施工时，若不当心溅触到皮肤或眼睛时，应立刻用清水冲洗，视状况看医生。施工时坚持良好的通风环境，不得在环境温度低于5℃湿度大于80%的情况下施工。施工时严禁与其它涂料及有机溶剂混合，以防蜕变。混配后的漆，尽量在规则时间内(2小时)运用终了，故应视状况酌量，防止一次配料太多，形成糜费，胶化后的漆不能运用。

1. Construction precautions of super-abrasion-resistant floor paint: it is not suitable to construct in fog if the construction site is not a sealed space, encountering fog or frost and snow and other climate, it can not be constructed. If the surface of the floor is covered with water vapor, construction should not be stopped. The solidification time of floor paint becomes longer when the construction distance is prolonged at low temperature in winter. Therefore, the time distance between construction processes needs to be prolonged. If the coating is really dry, the next layer will be constructed. Otherwise, the problems of color permeation and film delamination will easily occur. During construction, if not carefully splashed on the skin or eyes, should immediately rinse with clean water, see a doctor according to the situation. Good ventilation environment should be maintained during construction, and construction should not be carried out at ambient temperature lower than 5 C and humidity greater than 80%. It is strictly forbidden to mix with other coatings and organic solvents during construction to prevent metamorphosis. Mixed paint, as far as possible in the regular time (2 hours) to use the end, it should be considered according to the situation, to prevent too many ingredients at one time, the formation of waste, gelatinized paint can not be used.

2，空中硬化剂的作用：坚硬：经混凝浸透密封固化剂处置后的空中，硬度能进步40%以上;耐磨，耐腐蚀：可以将混凝土中的各种成分固化成一个坚硬的实体，增加了耐磨性;经处置后的空中，将大大进步了混凝土的耐腐蚀性能;防尘：固化剂与混凝土中的硅酸盐发作化学反响，在混凝土表层中构成一个无尘、致密的整体，永世控制了混凝土灰尘从外表空隙中析出;防滑：有效的阻止盐碱成份从混凝土外表析出，起到避免打滑的作用;抗压：经处置试样比未处置试样加强30%，抗折强度进步3倍以上;抗渗：有效渗入到混凝土内锁住水泥构造毛孔，进步密度起到密封效果，能有效抑止油污进入混凝土内部。

2. The function of air hardener: Hardness: hardness can be improved by more than 40% in the air after being treated with coagulation soaking sealant; wear resistance and corrosion resistance: various components of concrete can be solidified into a hard entity, which increases wear resistance; after being disposed of in the air, corrosion resistance of concrete will be greatly improved; dustproof: silicate attack in solidifying agent and concrete Learn to react, form a dust-free, compact whole in the surface of concrete, eternal control of concrete dust precipitation from the surface voids; skid prevention: effectively prevent saline-alkali components from precipitating from the surface of concrete, play a role in avoiding skid; compression: disposed specimens are 30% stronger than untreated specimens, flexural strength is more than three times higher; seepage resistance: effective infiltration into concrete to lock cement Constructing pore and improving density can effectively prevent oil pollution from entering concrete.

安徽塑胶跑道官方网站：http://www.ahxxdp.com/